REF_PS

PROXIMITY SENSOR DETECTOR (PSD) ERROR Cause Loose connection or PSD sensor is defective. Solution Check wiring and connections to PSD sensor. Check voltage to the PSD sensor. DETAILS BELOW:

DISH_F35

HEATED AIR TEMPERATURE SENSOR ERROR Cause Heated air temperature sensor is out of range Solution Check heated air temperature sensor resistance for 8~44kohms. Check heater for 40~45 ohms. Check heater for 120 volts. Examples of wiring colors are from Models LDTH7972, LDPH7972, LDPS6762 AIR DRY THERMISTOR CHECK Pin 1  RED wire to Pin 2 BLACK […]

DISH_F31

HEATED AIR DRY FAN ERROR Cause Heated air dry fan motor is not running Solution Check the Heated Dry Fan Motor for 12 Vdc. Check for PWM signal and feedback. DETAILS BELOW: Examples of wiring colors are from Models LDTH7972, LDPH7972, LDPS6762 BLACK WIRE Pin 1 = Feedback  2 ~ 4.5Vdc GRAY WIRE Pin 2 […]

DISH_CL

CONTROL LOCK FUNCTION (CHILD LOCK) Not an “Error Code” but will suspend operation of the unit. The control lock function is on to prevent anyone from changing cycles or operating the washer.   CHILD LOCK  (Control Lock) Use this option to prevent unwanted use of the washer or to keep cycle settings from being changed […]

DISH_NE

VARIO MOTOR ERROR Cause Vario Motor (Water spray diverter motor) has an error for not detecting that the motor is turning. Solution Check the motor circuit for proper 120 Volts ac and if no voltage then replace the Main PCB. Check the vario motor for resistance on the motor windings for 2.7~4.0 Kohms and if […]

DISH_FE

OVER FILL ERROR Cause Too much water supplied. Drain pump will turn on to pump out the water during this error code. Solution Water valve may be defective allowing too much water into the tub. Flow meter may not detect volume of water supplied accurately. Cause Main PCB may be sending voltage to valve constantly. […]

DISH_IE

WATER INLET ERROR Cause Water supply faucets are not fully open, or low water pressure. Water inlet hoses are kinked, pinched, or crushed. Solution Verify water supply valve under customer’s sink is fully open and check water supply pressure for 20psi or greater. Insure the water supply hose is not kinked, pinched or crushed behind […]

DISH_LE

LOCKED MOTOR ERROR Cause Wash pump motor error code Solution Check motor windings resistance value and check for proper voltage to the wash pump motor. Wash Pump Variable AC Voltage 3 wires = 24 ohms & voltage is variable AC 50~170Vac. Also check for possible obstruction or debris in the pump stopping the impeller from […]

DISH_OE

DRAIN ERROR Cause Drainage Problem. Main PCB does not detect that water has drained from the tub. Solution Check for a clogged, kinked or frozen water drain hose. Cause Air gap or disposal is clogged. Solution Clean air gap or disposal. Cause Filters are clogged. Solution Clean filters. Cause No voltage to pump. Solution Check […]