FL_DR

DRAIN FEATURE (NOT AN ERROR) Cause Special drain feature, not an error, indicates that the unit has timed out, and is automatically draining the water in the unit. Solution If the washer is paused during a cycle for more than 4 – 8 minutes, the cycle will be canceled and any water remaining in the […]

FL_UB

UNBALANCED INFORMATION CODE Cause [ub] is an information code indicating washer detects out-of-balance load and is automatically attempting to balance. Washer will add water and try to redistribute load. If successful, cycle continues and display of [ub] may alternate with time left in cycle. [ub] display is for information only; no action (or service) required. Solution Cycle selection is […]

FL_PF

POWER FAILURE Cause The unit has experienced a power failure, (if it has a display and showing “PF” you have power “now”). Solution Check for proper voltage at the customer’s source. Condition 120vac was interrupted to the unit. Possible Causes Unit unplugged during usage, Power Failure or Bad wiring. NOTE: “PF” is only displayed if […]

FL_PE

PRESSURE SENSOR ERROR Cause The Main board is detecting the Pressure Sensor is shorted or has an open circuit. Solution Check the pressure sensor harness for connection at the pressure sensor and at the Main board. Cause Small hole in pressure sensor tube. Solution Replace pressure sensor assembly. The pressure tube is only available with […]

FL_US

VIBRATION SENSOR ERROR Cause The vibration sensor is damaged or has experienced excessive vibration. Solution Check for loose connections at vibration sensor and Main PCB and possible damage to harness. Check for 5Vdc on Red to Black wires.  DETAILS BELOW: uS or u5 Error Code (Front Load Washer) Initial items to check as a bad […]

FL_DE

dE DOOR OPEN ERROR Cause Main Board is not seeing a closed Interlock Switch from the Door Switch. Solution Make sure that the door is closed properly. Check for warped or misaligned door. Loose connection at the Main board or door switch. Bad door Switch Bad Main Board. The washer will not operate unless the […]

FL_TE

THERMISTOR ERROR Cause The unit senses the Thermistor is bad or out of range. Solution Visually check for loose connections or damage to harness. Also check the thermistor for proper resistance values. DETAILS BELOW: Check Connections at Thermistor. (on some models the thermistor is part of the Heater assembly, others will have a stand-alone thermistor […]

FL_UE

UNBALANCED ERROR Cause The load is too small. The load is out of balance. Solution Add additional items to allow the washer to balance the load. Manually redistribute the load if articles have become tangled Cause Heavy articles are mixed with lighter items. Solution Wash articles of somewhat similar weight to allow the washer to […]

FL_LE

LOCKED ROTOR ERROR Cause   The motor can not turn Solution  Check for tub moving freely by hand and if does not may be a bad tub bearing, cracked magnets on the rotor, stator windings resistance greater than 15 ohms or less than 5 ohms, foreign item between tubs. Some models have a hall sensor that […]

FL_OE

OUTLET ERROR “DRAIN PUMP ERROR” Cause Drain hose is kinked, pinched, or clogged. Solution Make sure that the drain hose is free of clogs or kinks and is not pinched behind or under the washer. Cause The end of the drain hose is more than 96 inches above the bottom of the washer. Solution Move the end […]