WAC_02

PIPE TEMPERATURE SENSOR ERROR Cause Open /Shorted Sensor. Solution Check ohm reading of sensor. Cause Sensor disconnect. Solution Check for connection of sensor to Main PCB Cause Sensor harness damage. Solution Inspect the sensor harness for damage/breaks. Check for moisture around connector. DETAILS BELOW:

WAC_01

ROOM AIR TEMPERATURE SENSOR ERROR Cause Open /Shorted Sensor. Solution Check ohm reading of sensor. Cause Sensor disconnect. Solution Check for connection of sensor to Main PCB. Cause Sensor harness damage. Solution Inspect the sensor harness for damage/breaks. Check for moisture around connector. DETAILS BELOW:

FL_LOE

LID OPEN ERROR Cause When the detergent dispenser lid is open the washing or drying feature is disabled.          Solution Close the detergent lid tightly. Check for any damage to the dispenser drawer or housing assembly.

FL_DHE

DRY HEATER ERROR Cause Dry heater is not heating Solution Check dry heater resistance for 10 ~14Ω or 33~37Ω (Depending on Model) Check dry heater voltage for 120 V ac Check thermistor 2.5 ~ 180KΩ Check Dry Fan for 24Vdc Check Dry Fan for 2~5 ohms on each winding U~V, U~W & V~W Check thermostat for open […]

FL_AE

LEAK ERROR (Front Load Washer) Special Note: The AE Error has different meanings based on if the Washer is a Standard Front Load or a Heat Pump Combo (Washer/Dryer Combo) unit. Troubleshooting for both styles is described in the article below… Heat Pump Combo Info (Click Here) Standard Front Load Washer: Cause An internal leak, […]

FL_LE2

COMPRESSOR ERROR Cause The Compressor is not running. Solution If the connector for the Compressor is disconnected, or it has a contact fault. Reconnect the connector and correct the poor connection. Check the Compressor Harness for continuity. Replace Harness. Replace compressor.

FL_LE1

FAN MOTOR ERROR Cause The fan motor is restricted. Solution If the connector for fan-motor connection is disconnected, or it has a contact fault. Reconnect the connector and correct the poor connection. If the harness between the fan motor assembly and controller is open. Replace the harness fan-motor. DETAILS BELOW: 3 phase 24 Vdc Motor […]

FL_DE4

DOOR OPEN ERROR Cause The door sensor has malfunctioned, the door sensor is contained inside the door lock assembly, please replace door lock assembly.  Solution Make sure that the door is closed properly. Check for warped or misaligned door. Loose connection at the Main board or door switch. Bad door Switch For further troubleshooting please […]

FL_CD

COOL DOWN (NOT AN ERROR) Not an error code Programmed temp is reached Heater turns off 5 mins will display  [Cd] (cool down) displays at end of cycle Cool down will continue for up to 4 hours Thermistor temp does NOT terminate Cool Down Unit will intermittently tumble: 4.5 minutes off / 30 seconds on […]

FL_CL

CONTROL LOCK FUNCTION (CHILD LOCK) Not an “Error Code” but will suspend operation of the unit. The control lock function is on to prevent anyone from changing cycles or operating the washer. Use this option to prevent unwanted use of the washer or to keep cycle settings from being changed while the washer is operating. […]