CLEAN THE FILTER ERROR

Cause

The Top filter is restricted

Solution

Clean and replace the Filter and advise the customer of proper maintenance. (The Heat Pump dryer uses the duct in, duct out, and pipe sensors to determine airflow and heat. If you had a sensor bad you should get a sensor error).

DETAILS BELOW:

Remove and Clean the Outer Filter
Routine maintenance should include remove the Outer Filter and clean before and after each use. Grip the Filter Cover and pull it toward you as you lift it.

Hold the Filter assembly over a trash receptacle and pull the handle on the front of the filter gently, then slide the mesh filter out.

This will automatically remove the lint. (Further cleaning can be done using a vacuum cleaner, or rinsing it with water), if water is used make sure the filter is dry before reinstalling if the unit is not being used, or it could cause odors.

Reinstall the mesh filter.

Remove and clean the Inner Filter.

It is recommended to clean this filter and the condenser area after at least 10 loads.

Grip the internal filter and pull straight, to remove, then clean.

Reinstall the Inner Filter assembly.

Reinstall the Condenser grill and the screw holding it in place.

Reinstall the Filter assembly into the top.

Leave a Reply

Your email address will not be published. Required fields are marked *